![]() If anyone has any help on this, or more questions for me, please respond, I'm really stumped here. I'm concerned that I don't see the community boards swimming with people in my position, Id almost feel better if they were. I have now installed this on three machines, using three different dongles (We have four)and I arrive at the same issue. OzCAD had me wait for the Service Pack 1 in hopes that that would fix it, today hat service pack was released and after installation I'm still in the same position. We also un-installed and reinstalled the ''correct'' drivers for the HASP dongles. I hadn't used that shortcut anyway, but I thought Id mention it here. I have spoken with our Distributor here in Australia and they assured me my dongle is the correct series and that the only known issue was the shortcut from the windows menu failing. Make sure that the dongle is connected and all required drivers are installed. After installation I routinely rebooted the machine and on trying to start up I get ‘A Vectorworks Dongle could not be found. The machine has VW2014 still installed on it in case that's a factor. On initial release I installed VW2015 on the system listed in my signature. I'm hoping someone out there smarter than me has hit this issue and overcome it. I have been battling this issue since the release of 2015 here in Australia. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |